Home » Wireless HDMI » HDMI Extender over Cat5e or Cat6 Cables – Up To 30 meters 98 feet – Fixed 10-Inch


Category : Wireless HDMI
Do not lose your chance to get this rare opportunity!
* Discount only for limited time, Buy it now!



"This Best Selling HDMI Extender over Cat5e or Cat6 Cables – Up To 30 meters 98 feet – Fixed 10-Inch Tends to SELL OUT VERY FAST! If this is a MUST HAVE product, be sure to Order Now to avoid disappointment!"

HDMI Extender over Cat5e or Cat6 Cables – Up To 30 meters 98 feet – Fixed 10-Inch


HDMI Extender over Cat5e or Cat6 Cables - Up To 30 meters 98 feet - Fixed 10-Inch


HDMI Extender

  • Supports 1080p, 1080i, 720p, 480p, 480i
  • Supports Deep Color
  • Supports Dolby True HD 7.1 and DTS-HD
  • HDCP Compatible
  • Extend HDMI Signal Up To 30m (98ft)

We have searched the web to find the best prices available. Click Here to find out where to get the best deal on HDMI Extender over Cat5e or Cat6 Cables – Up To 30 meters 98 feet – Fixed 10-Inch

Check for Special Price Today!

Wooww, nice product! I want to share this product!
facebook
twitter
stumbleupon
Delicious
reddit
Digg

What customers say about HDMI Extender over Cat5e or Cat6 Cables – Up To 30 meters 98 feet – Fixed 10-Inch?

  1. 51 of 52 people found the following review helpful
    4.0 out of 5 stars
    Mediabridge HDMI Extender Baluns, March 15, 2011
    Amazon Verified Purchase(What’s this?)
    This review is from: HDMI Extender over Cat5e or Cat6 Cables – Up To 30 meters 98 feet – Fixed 10-Inch (Electronics)

    I used these to connect the DVI-D output of an nVidia GeForce 7900 GS to the HDMI/DVI input of a Samsung UN55B8000XF at 1920 x 1080 60p. For cable I used the Amazon reference sell CiTi Electronics 100 feet Cat6 x 2 which cost $16.25 each. There was no signal at 100 feet so I cut the cables to 86 feet and re-terminated. This produced a very noisy signal. I cut and re-terminated again at 75 feet (which was as short as I could go) and the signal was excellent. I used a MediaBridge DVI-D to HDMI adaptor at the sending end. Your performance will depend on the sender and receiver’s circuitry, as well as the cable used, but I’d say it’s very likely you’d get 75 feet of range using cheap Cat6 at 60p. I also tested range using an OPPO BDP-83 as source: nothing at 100 feet, acceptable signal at 86 feet and 24p, unacceptable signal at 86 feet and 60p, excellent signal at 75 feet. It is highly unlikely you’d get an acceptable 1920 x 1080 60p signal at 30 meters, but you should be fine at 23 meters with Cat 6. Recommended.

    Help other customers find the most helpful reviews 

    Was this review helpful to you? Yes
    No

  2. 13 of 13 people found the following review helpful
    5.0 out of 5 stars
    Great product, it “just works”. HDMI 1.2a compliant., March 27, 2011
    By 
    Deepak

    Amazon Verified Purchase(What’s this?)
    This review is from: HDMI Extender over Cat5e or Cat6 Cables – Up To 30 meters 98 feet – Fixed 10-Inch (Electronics)

    I could not find the specs for this product when researching HDMI extenders. In particular, I wanted to know which HDMI version number the product was compliant to. The low price and positive reviews led me to purchase it anyway. A tiny user manual is included with the product and the specs therein seem to indicate compliance to HDMI 1.2a (to be more precise, the field labeled “Output Video” says “HDMI 1.2a”).

    I have the sender/receiver set up with 35 ft of Cat 6 cable transmitting 1920×1200 at 24 bit depth. This is the maximum resolution/color depth specified for HDMI 1.2a.

    A note applicable to Windows XP users and perhaps users of some other OSes: The OS may not show a 24-bit color depth, though it offers 16-bit and 32-bit. 32-bit is actually 24-bit RGB with 8 bits assigned for each primary color. This has to do with the OS addressing memory by 32-bit words; the remaining bits are unused.

    The cable run for my setup isn’t very long, but still, I’m impressed by how it “just works”.

    One more thing for those that may care — there is no apparent delay introduced with this product. I was concerned about possible delays in the signal which might impact, for instance, gaming. Having thought about it a bit, the propagation delay must be miniscule. The internal clock runs at 165 MHz which corresponds to about 6 nanoseconds per cycle. Which would mean that even if 1000 cycles were required for a bit to pass through either the sender or the receiver (which would be a very conservative estimate for the number of cycles), that would still only amount to about 6 microseconds. And as for the prop delay down the cabling, I don’t need to do the calculation to know that that value would be even more miniscule. Bottom line, any delay introduced would be some very very small fraction of a millisecond, which would be for most intents and purposes non-existent.

    Help other customers find the most helpful reviews 

    Was this review helpful to you? Yes
    No

  3. 18 of 21 people found the following review helpful
    5.0 out of 5 stars
    Plugged it in works great!!!, October 3, 2010
    By 
    Mark “Mark” (Salt Lake City, UT USA) –

    Amazon Verified Purchase(What’s this?)
    This review is from: HDMI Extender over Cat5e or Cat6 Cables – Up To 30 meters 98 feet – Fixed 10-Inch (Electronics)

    Have a Dishnetwork HD Satelite receiver in our data rack, have a LCD HD TV located in our Exercise room. Wanted to get HD on that TV. Plugged the HDMI “Sender” into the Satelite receiver, plugged 2 6′ Cat5e patch cable into that and plugged it into the Patch panel for our network. Then about 60′ of Cat5e cable in the walls to the room, from the wall plate in the room to a 1′ Cat5e patch cable to the HDMI “Receiver” and plugged it into the TV.
    Turned on Satelite, turned on TV. Nothing… DANG right where I left off with the SABRENT HDMI Extender which only worked for about 2 mins and then an hour the next day (Not recommended).
    Humm, did I cross connect the CAT5e patch cables???? Switched the two Cat5e cables, PRESTO came up just fine. TV synced up to 1080i and the picture looks great!!!!
    This worked great, and other plusses for this product. Already included 10″ HDMI cables as part of the Sender/Receiver so it works great on the back of the Satelite receiver and the back of the TV without another connection to worry about. Plus the receiver doesn’t need a power adapter.
    Can’t believe I waited so long to try one of these out, plus the price was right.

    Help other customers find the most helpful reviews 

    Was this review helpful to you? Yes
    No


WD My Net N900 HD Dual Band Router Wireless N WiFi Router Accelerate HD

Check Special Price!
New toy! Asus Wl-520GU Image by cibomahto My new toy came...

TP-LINK TL-WR1043ND Ultimate Wireless N300 Router , Gigabit, 300Mbps, USB port , 3 Detachable Antenna x3/ IP QoS/ QSS Button

Check Special Price!
WRT54G – Linksys Wireless Router- Front – Open Box Image by...

HP 920XL Black Officejet Ink Cartridge

Check Special Price!
HP 920XL Black Officejet Ink Cartridge The HP 920XL Black Officejet...

CCNA Portable Command Guide (2nd Edition)

Check Special Price!
CCNA Portable Command Guide (2nd Edition) CCNA Portable Command Guide Second...

For all your Wireless Needs at the Lowest Price
Low Cost Wi-Fi is a participant in the Amazon Services LLC Associates Program,
an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com